Extend Rust Neutralizer Spray

I use this to prevent the spread of rust on our 15 year old odyssey. A little light sanding, spray this stuff and then some “close enough” paint

This is my all time fav anti-rust spray. Easily paintable when dry by other types of paints. It dries fast. It converts rust from red Fe2O3 to stable black Fe3O4. It has gone from $7 in 2022 to $16 in 2026. It is almost too costly to purchase but there is nothing else that compares.

Product converts rust well, but the tip broke off in shipping, so not packaged well enough. Crammed it back in and it works well enough for now.

I have used this for years on the underside of my vehicles. I have a 1995 camaro any rust appears underneath i spray this let it sit a couple of days then paint. Seems durable never had any returns where treated. Please make sure you shake it well otherwise it doesn't work properly. I found that out.

Both cans worked fine. It goes on CLEAR. This is the only rust inhibitor/neutralizer I'd buy as all the others go on black and you can't see the status of the rust under them!

I use it around the house where rust is an issue. It doesn't necessarily prevent rust. It reduces the spread with good rust prevention methods.

used to control rust

Loctite 633877 is NOT the same as naval jelly. I was misguided by another listing into buying this thinking it contained phosphoric acid like naval jelly which *can* dissolve rust without causing rust flashing (I had rust flashing issues with evapo-rust in the past). This has an active ingredient of tannic acid and basically a primer suspended in acetone and butane which sucks, it peels with your finger nail. It converts rust to a black surface but not consistently, leaves a patchy clear-coat* film, AND it causes rust flashing on non-rusted surfaces. *the clear coat film has reacted metal particles in it so it leaves a black or orange smudge permanently on your parts. This product is horrible. I regret buying it and cannot return it. I recommend everyone wanting to buy this product to go look at youtube tests with rust removers, they found some with phosphoric acid that work at dissolving rust. I personally gave up on chemical removers and removed rust physically with my makita drill, wire brush, and a felt pad on an angle grinder to buff out some of the scratches it left behind. The best way to stop rust is prevention so I use aerosol gun care oil. It works better than this loctite junk. Included pictures. Coat your tools before they rust, do the same with components in your car, they sell various sprays. Gun oil can also remove rust parts with hinges (such as pliers) by suspending the particulates in oil and lubricating it with a protective layer left behind, mine is also dry-to-touch (typical rust removers/converters cannot do this especially not this one with a primer that would act as a glue). I think this loctite product was made for landlords to “fix” old rusty things around the house by spraying this crap on it, then coating it in more latex paint. I would never use this on anything I cared about, this product ‘fixes’ nothing it is a bad excuse for a bandaid. No I do not recommend this product. It actively creates rust, burns to touch, and smells awful. The drying time is long too. The only benefit was this was cheap for a big can. lol. Wanted to leave one last update, I sprayed half the can on a badly rusted hammer with this and it turned completely black. I can leave an update on it after a few years to see if it holds up.