Car Door Entry Guards

GREAT STUFF... 10 + Door edge guard, some car dealers charge $500. for this stuff. I put it on all my car door edges

I didn’t use this for car door edging. I used it to edge DIY lids for aquariums. I made the lids out of twinwall polycarbonate which provide rigidity and allow 80% of light through. One drawback is that the airspace of the twinwall is exposed at the ends and water will get inside. I used this tape to seal the edges. It is crystal clear, completely waterproof and sticks well to the polycarbonate. The lid looks fabulous on my rimless tank and does not detract from the “glass box” look. I’ll be making this style for all future fish tanks. I did let it cure after application for 24 hours before exposing it to the wet environment. It sticks well, but you can also remove it without leaving an adhesive residue. I’m finding all sorts of uses for this tape now. It’s silicone under a shiny clear flexible and slightly stretchy plastic. It’s so clear that it doesn’t detract from the appearance of anything I’ve used it on. I have an old 1960s metal fishtank hood and I kept cutting my hand on the sheet metal. I used this tape to edge the sharp edges and now I don’t get cut. And it doesn’t look bad. Previously, I might have chosen electrical tape, but this is a much better solution. I’ve used it to edge glass And patch a pinhole on an inflatable plastic alpaca. It’s: Crystal clear - surprisingly so 100% waterproof Sticks to a variety of surfaces Doesn’t leave a residue when removed Provides slight thickness and padding Easy to apply Conforms around gentle curves Easy to cut Can be repositioned before you press it down I don’t need to edge any car doors, but aside from a possible challenge to apply it straight (it is basically tape after all), I think it would work fine.

Looks like this product was merged with others. The one I bought is the 1/2 in clear plastic tape film. They looks alright in places where the surface is easy to blend in. The surfaces that are harder to put on are the super curvy one like the mirrors--you'll get the tape bunched up a little. It's also kind of difficult to cleanly cut the tape with regular scissors--you probably need a sharp one to have clean ends. The ends seems to peels a little because of the weak adhesive power. It's not like this is adhesive tapes but they stick on quite well if you don't mind the ends seems a tad bit out of place. But from a distance, they are soft of invisible unless you really look for it--I say this despite having a red car, a black or white ones would fare better.

Terrible. Impossible to cut. Just sticks to scissors or knife. Hard to put on and SO thick you can't use more than 1 piece like to make wider or around a curve as it shows terribly. I took it off immediately and it peeled my paint off my bumper. Terrible.

$12 to expensive for this

Interior last over a year before rolling on the ends. Exterior still lasting longer. But look at the length?! Wasn't enough to do one door frame or anything.

I just purchased a 2020 RAV4 XSE Hybrid. Although I installed OEM door sill protectors, it still left an inch or so unprotected. I ordered the 2” width and cut 14” for the front, 8” rear and sliced the pieces in half. I’ve always found that slightly rounding the corners with scissors helps with longevity. I also used a heat gun to soften the material before applying to help with adhesion. It is a little tricky to apply because of air bubbles, this tape doesn’t like to be pulled up and reapplied because it’ll stretch and crinkle up. Fortunately there’s plenty of material to start over which I did several times before getting it right. We’ll see how it holds up over time.

We recently bought a new house and our dog keeps scratching at the sliding back door. We purchased this to put along the metal part of the door to prevent the dog from scratching the paint off. So far works perfect for that and has not peeled off. Great quality and you can’t even tell it’s there.

Fantastic Product would recommend. Sticks and even with the heavy rain does not come off.

Its strong double sided tape not for use as protective strip for the car.

Not an exciting thing but the thick flexible clear tape does exactly what it is supposed to do, and one year on, it is still in place.

it's doing its job. Protecting the surface but you won't notice it's there. As it been raining lots. it doesn't get dirty.

Good use for straight hidden car body parts such as inner rocker panels. Good low cost. Easy to peel if needed, no residue left so far. It is thick and quite protective. It is not that easy to apply for curve edge and likely not looking good, wringle and bubbles wont be easy to manage for most -- would not reccommend for curve edge or curve var body parts.