Barrow G1/4-10k Temperature Sensor Blank Plug - Shiny Silver

Fitted perfectly in the G 1/4 threaded holes and temperature reading comes through fine into the Aquaero 5 LT. Not sure if the reading is 100% accurate but it's good enough and can't complain for what you pay.

Connected Easily. Works Perfectly. I installed 2 of these at the Radiator-In and Radiator-Out points of my coolant loop and hooked them into the motherboard headers. At the same time I installed an in-line LED temperature meter so that I could see at-a-glance that everything was good too. I used a couple of three-way connectors to give me the ports to attach these but they went in easily and even being hand-tightened was sufficient ensure there were no leaks. I've added a photograph and it's kind of tough to see but the sensor is hooked up between the 90° fixture that turns-the-corner to my in-line temperature meter, and the "out" port of my radiator. The second one is off to the right where the coolant feed comes in from the motherboard-coolant-out.

Accurate sensor with a good seal. I use this in my setup with a Corsair Commander Pro to control fan curves and it works great!

Callers say my voice sounds muffled.

Works great. Now I can use the water temperature to control the radiator fans so I don't have to listen to them rev up and down every time the CPU is busy for a couple milliseconds.

I can't test accuracy but it seems to work fine