CNC Spoilboard Surfacing Router Bit, 1/4 Inch Shank Slab Flattening Planing Bits 1'' Cutting Diameter Carbide Planer Bit Woodworking Router Tool

Perfect for flattening cnc router wast boards, at a reasonable price.

Got this to use with a diy router sled i made, works a treat

I needed to surface my new spoil board. the value for money with this is great and came sharp, I did accidentally crash it into the board but that was 100% my fault

For a beginner nice tool. Time will come whenever more experience leads on to more professional cutter with an increase in, price.

As you can see from the picture, I'm using this with a battery powered router. It is sharp enough to cut through MDF without getting snagged, and with my setup, is giving me clean enough results for me to be happy. I'm limited by the router to this size head, and it will take time to skim an area, but so far it's been a robust purchase. Total runtime so far is about 6 hours of use. I'll be happy to buy again if I damage this one.

The tool became dull after just a few uses on soft wood.

This bit has a short shaft which is good and bad. Good - less likely to bend out of true while cutting hard material; Bad - base of the router must be close to the workpiece so flattening jig must be thin eg 8mm ply. So far ive used this to flatten 2 square meters of jointed teak and at the end it's still quite sharp and it did a good job on the surface. Would I but again? No, for the stuff I do I would go for a longer 1/2" shaft and wider cut area. It's great for small jobs though, and works well in a trimmer. It also comes with a handy storage container.

Perfect for flattening on my XCarve, very good performance, nice and sharp out the box and stayed sharp after multiple uses.

Fräser drei Messer

Ben fatta ma piccola

Ho acquistato questa fresa per piallare una tavola di noce ha fatto il suo senza problemi.

Leider ist der "Stift" nach 3 Monate einfach gebrochen!

Supersoddisfatto