235mm Spring Steel Sheet

Wow! Holds like magic. Part finish on the plate surface looks awesome too. Bye-bye, warpage. No brim necessary, and saves heat energy (don’t need to heat bed plate up as hot). Good job!

Best plates ever. This is the only Plate I would use on my bambu printers. Haven't had a first layer failure.

One side lasted 4 days after the return window closed. That spot has no tackiness to it now.

I was excited to see the Frostbite for the A1M, having only bought them for my larger printers so far. I don't know if this was a bad batch or something, but it basically fell apart after only a few weeks. Regular PLA printed at regular temps, always let to cool before removal. Same way I treat my full-size plates. This one failed MUCH faster than the others, with the coating coming off around the edges (hence where it peeled at the prime line) and bubbling up and tearing in the middle of the plate. My others wore out as well, but only after months of use and several hundred prints. This one started bubbling up after like the 10th print and outright failed after no more than than 40 prints 🙁 The Glacier is holding up fine, but the Frostbite's dead so I replaced it with a GECO.

The adhesion is good, but it didn't even last a month before it started to peel, so I definitely recommend going with something else.

Llevo un mes con ella y me ha encantado! Con el 90% de las impresiones salen excelente a solo 35° con PLA, pero las que si se han llegado a despegar recomiendo 45° pero es muy raro que pase. Otro detalle es que se empieza a "pintar" de las impresiones, pero es meramente estético.

great

Super grippy

Disappointing - delaminated on first use with grey Bambu PLA - blue "frostbite" surface peeled off in two places about the size of a nickel and a dime ... ruining both the print and the bed plate. Apparently this is supposed to be a GREAT bed plate ... but in this case the Blue plate just BLEW.