Chanzon LED Driver 300mA (Constant Current Output) 18V-34V Power Supply

I bought this to replace the circuit board in my AmScope microscope built in snake light. It’s about half the size of the circuit board and self contained. It works great and it was easy to install with a soldering iron and some heat shrink tubing.

I have 3 Costco L.E.D. outdoor lanterns. I call them porch lights. A few months ago, one failed. Costco still sold it, so I traded for a new fixture. A few days ago, another failed. The light was dim and constantly blinking on and off. Costco no longer sells that model. I could buy a new one, but it wouldn't match the others. I Googled the issue and found that the "driver" in these units can fail. There were YouTube videos showing how to replace the "driver". Inside the lamp head are a photocell, a driver and the cluster of L.E.D. lamps. The driver seems to work as a power supply for the lights. It has two wires for the power input and two wires to the lights. The O.E.M. replacement driver was hard to find online. It seems to sell for $37.50 on up, plus shipping. One of the videos showed this unit. I decided to take a chance. It arrived today. I installed it and it works! This driver sits loosely inside the lamp head, but that's ok. I am completely satisfied. The photo is similar to my lanterns.

The driver that controls one half of the LED strip light in my kitchen quit working. I found this drive for about $10 and it works well. It isn't quite as bright as the original but so close it is unnoticeable. I would give it 5 stars but it's only been in service for a couple of weeks.

Lasted two weeks

This was a super simple install and immediately fixed my broken led fixture. So glad I found this.

I bought what would have been very expensive LED shop lights at a thrift store and one of them would sometimes blink off and eventually stop working for a while. I checked with a bench power supply that the LEDs themselves were fine and ordered this driver based on the specs printed on the one in the fixture. It works perfectly and is small enough to fit inside the fixture, and looks better made than the part it replaced.

Nicely packed and good quality product. I am hoping it will last a lot longer than the original factory LED driver that came with the lantern.

This stopped work after 3 days bad product will never buy it again

Arrived quickly. Good value. The light up quickly. Used in the kitchen, so used all the time. I have used this make of driver for about 6 months and so far they have lasted and performed.

replacement driver for LED light ftting