Question 1

Do I have to perform a ride height trim procedure.  If so does this need to be done at the time of installation?

Accepted Answer

It is recommended to run a retrim procedure post-installation on SUVs / truck for ALL bypass kits (from any seller) for GM active suspensions.  it is a simple procedure that can be done with a snap-on or pretty much any OBD based tool. It only takes minutes and helps to reset the vehicle and stabilize it for maximum ride quality and safety.  If you don't have a computer, any shop can do it in about five minutes.  if it's a older car like a Corvette etc. you do not need to run a retrim.

Question 2

Can you remove compressor after these are plugged in so that it never cuts on?

Accepted Answer

Yes, if you have air suspension on the rear axle you can install the simulators on to the 3-pin ride height sensor to simulate a static position so that the compressor does not activate based on the load in the rear of the vehicle. After installing the right height simulators on the rear axle and replacing the air ride with another passive suspension system you just plug the air hoses.  The air compressor will still turn on when you start the vehicle but all it will be doing is pressurizing the hoses while ignoring any height changes due to our simulators being plugged in.  If you are replacing Magneride struts on the front suspension you will need another kit to bypass the ride height sensors AND the front Magneride struts.

Question 3

Anything for a 2020 denali 1500?

Accepted Answer

Sierra, Silverado and Denali Trucks 2019-2023 use the Z45 suspension which utilizes a higher power MagneRide system than older GM vehicles. This kit will fit your 2020 Denali, however, we can not guarantee its long term functionality .  You are welcome to give it a shot and return it if it does not work out for you.

Question 4

will this work for a 2015 yukon denali with z95 suspension?

Accepted Answer

Yes.

ASIN	B0B745LTTK
Best Sellers Rank	#27,320 in Automotive ( See Top 100 in Automotive ) #15 in Automotive Replacement Shocks
Brand	M&P USA
Customer Reviews	4.2 4.2 out of 5 stars (270)
Date First Available	July 20, 2022
Exterior	Machined
Item Weight	3.84 ounces
Item model number	MPUSA107
Manufacturer	M&P USA
Manufacturer Part Number	MPUSA107
Model	M&P USA13-22
Package Dimensions	5.16 x 3.5 x 1.06 inches

Late 2013-2019 Magneride Bypass Kit

Details

Details

Description

Specifications

Common Questions