Shop Fox W1322 Anti-Vibration Pad 24-Inch by 36-Inch, Black

Super adhérence pour stabiliser la pièce à travailler.

Works great for my application! I started investing more money in my 3D printing set up and I purchased a large plywood sheet of 3/4" thickness and cut it into a 2'x3' section to provide an ample surface for my two 3D printers.The table I use is a six 5-gallon water jug holder [ ASIN: B001I0EFIO ]. With that said, the table's plastic nature would slide all over the place on my garage polished cement floor. Purchasing this mat both reduced my vibrations and completely got rid of the slippage issue. I've bought smaller adhesive backed rubber patches and stuck them on the sides of the 3/4" thick plywood base where they make contact with the wall. These improvements were about $50 dollars however for my 3D printing needs they greatly improved the quality of prints and they also look quite nice when installed. Regarding the smell; I purchased a used pad from Amazon Warehouse which I assume was a return for such common complaints. Since this was going in my garage I did not care about this in the first place. Once I received it, I can confirm it has an odor to it but its not as excessive as others may state. I gave it a few squirts of Fabreeze and that seemed to do some work on the odor. Finally, yes I highly recommend this if youre looking to reduce vibrations or provide friction to the base of your table. I'm planning on buying a second unit to put directly on top of my ply wood sheet. I already test fit the one I put on the floor when I initially received it; the pad is a little bigger than the 2'x3' dimensions they provide however its always better to receive more than less, I can always cut the excess off If I desired.

Excelente material. Hasta el momento solo lo he utilizado para ponerlo en el marco de una puerta de metal, así cuando se azota amortigua el golpe y los cristales no se rompen, además de que no hace tanto ruido al cerrarse por el viento.

It does a good job keeping the wood from moving.

I needed some strips of neoprene to use as padding when installing some items on a recumbent bike. You could do the same thing with a mousepad or whatever, but this pad was large enough and reasonably priced so I went with this. It is well made although a bit smelly for the first few days after you open the package until it has a chance to air out. I also used a small pad of this to fashion a shelf to hold the TV remote on my bike while it is installed on my trainer. The pad works great - anti-vibration and also anti-skid. I don't have to worry about the remote sliding around on the shelf while I pedal.