2-Pack Coffee Replacement Brew Basket Spring Loaded Stopper Kits Fits For Mr. Coffee Black and Decker Hamilton coffee maker parts, Parts Number 990117900 990237500 Coffee Machine Accessory

I have a Crux automatic coffee maker. I found out that Crux no longer provides parts. So I bought this brand and it fit perfectly. Installation was easy and the white little rubber Grommet that fits inside the center of the drip system stretched on easily and stays in place. I’m glad I purchased two just in case.

My coffee maker stopper spring holder came off and is no where to be found. I found this on Amazon. Perfect fit and works well. Now, I do not have to replace my coffee maker.

Nicely made, super easy to put together and I’m sure they would've worked perfectly if I had needed that particular one. I didn’t care, I really just needed the spring and the silicone ring that holds it together. Those work perfectly. No complaints or regrets on the purchase. I’d buy em again if or when I need.

Parts were fine,however the washer is very tight and difficult to install. Really a two person job!

The replacement stopper for my Black and Decker coffee maker works fairly well, it drips a little pulling out the coffee pot, but I don't think it would stop dripping completely until the coffee pot is fully clear of the stopper.

works fairly well

It fit my Hamilton beach coffee pot just fine. Installing it was straight forward. The only tricky part was fitting the little white grommet.

If you need to replace this in the 2-5 cup Mr Coffee machine, the new round black windmill looking part is too big. However, use your original black windmill looking part plus the new spring and new round gasket and it will still work. You will need a needle nosed pliers in order to remove the original gasket from inside the filter basket. Take care not to break the tip of the black windmill part while you’re trying to get the gasket off. So precision is needed in order to get the gasket off of the original black windmill part. So use the original black windmill part from your Mr. coffee machine and reinstall the original black windmill with the new spring and the new gasket. The new gasket goes over the tip of the black windmill post inside of the filter basket. You will need some patience to get it in place inside the filter basket, but it will work. After you think you have it on the black windmill post, push it down gently with the needle nose, pliers to make sure it’s secure. Now put the filter basket in the Mr. coffee machine and run maybe a cup of water through the machine to see if the new set up is working properly. So you’ll put a cup of water in the reservoir and make sure your coffee pot and your filter basket are on the machine like you were making a pot of coffee.

Que cumplió con su propósito. Componentes para cafetera Hamilton Beach

Worked perfectly.

Super article

No funcionó en mi cafetera

Returned. Doesn't fit.