Accusize Industrial Tools 1''/25 mm Mini Precision Toolmakers Insert Vise, 3541-0050

Excellent design, but requires thoughtful handling while tightening. The mechanism inside to select which position you’re tightening from (based on the size of your work piece) is very tiny and can easily rotate inside the vise to a useless angle. It seems a bit short, but little can be done about that… it is what it is. After working with this vise for a few minutes your fingertips will develop a sense for when the ratcheting piece is properly placed in one of its notch sets and you simply have to maintain pressure from underneath to keep it where it belongs as you tighten the moving jaw with the Allen wrench. The moving jaw is a fraction of a millimeter narrower than the overall body (26 mm) of the vise so that you can loosen it when the small vise is being held by a larger one. There are built-in parallels for mounting small objects and the overall height of the thing is just right to clear the tops of my two inch vises. Wonderful design, really.

Nice little one inch vice, the finish is reallly good precision ground to a shine and the tolerance between the body and the moving jaw is tight, operation of the moving jaw is silky smooth. Exactly what you would expect from a precision machinist vice even at such a small scale.

Really handy for small part, jaws and flat areas are .0002”ish.. Works well for me!

I am a Tool and Diemaker by trade and needed to replace other mini grinding vise which was poorly made. This vise does what I need it to do and it seems to hold fairly well and accurately. I would recommend it to someone who needed one of these without spending a hundred dollars more. The vise comes in a basic plastic ribbed, splitting case similar to what an endmill would come in.

Its a small little guy... well made and clamps down super tight...

Not bad for the price and stayed +/-.0002” for most checks but did need reworked for more precise machining operations. The rear cut corner was .001” uneven top to bottom and has a uncentered undercut that barely has enough clearance for sharp corners. The inner jaw rails could have less give and would’ve been better if it was a tighter fit for so it can be reworked opened for personal preference. The bottom of the cut corner of the jaw was also .0005” higher than the back cut corner. The whole vise needed burrs removed upon receiving it.

Super quality, a nice addition to our tooling.

Used this vise over and over. It's precision and good quality. Won't be using it often since I changed jobs and won't be working with small details for dies. Still a solid vise. Should come in handy when I have to key in punches to grind flats in smaller shank sized punches.

Perfect for model making

It's used to hold a group of small brass disks in order to drill a .030" oriface in each one. The vise wil be fastened to the base of a precision micro drill press.

parece templada y le ayuda las muescas superiores para redondos cierra bien y está rectificada