NERMAK 2 Pack 12V 10Ah Lithium Ion LiFePO4 Deep Cycle Battery, 2000+ Cycles Rechargeable Battery for Solar/Wind Power, UPS, Scooters, Lighting, Power Wheels, Fish Finder Built-in 10A BMS

después de meses usándolas, diversos cortes de energía al en estos meses, puedo decir que respaldan mucho mejor que las que traía mi UPS de ácido, sin duda compraré más este tipo de productos por su relación precio/calidad

I’d recommend against usage for “legacy” UPS lead acid battery replacement, specifically the common case of quantity 4 or 2 battery systems. These usually are setup with the batteries in series (4x12v = 48v, 2x12v=24v). You are likely better off throwing the legacy lead acid battery UPS away, and buying a lifepo4 based UPS. Even the Lifepo4 portable batteries like the power 1000 have UPS capability. The ups devices that start with a lifepo4 energy source usually have passive and active cooling for the battery array, in addition to the inverter components. There are a few problems with using these in a legacy lead acid battery UPS: 1. The continuous output current is far lower than lead acid batteries. The typical Lifepo4 compatible battery option is rated at 10amp continuous. So, in a 4 battery series system, you’ll get at most about 135w continuous output per battery - so about 500watt max. You won’t get anything near the potential needed in common 1000w, 1500w, and 2000w ups. 2. The BMS present in the lifepo4 batteries generally needs at least exposed passive cooling, or even active cooling. These are enclosed package batteries, so cooling is limited at best. 3. With 4 12v lifepo4 batteries in series, you’d basically need another BMS to manage the 4 batteries, or the discharge and charge levels between batteries becomes imbalanced. 4. The charging circuit will not fully charge lifepo4 batteries, in most cases. Lead acid vs. lifepo4 have different max voltage levels. 5. The legacy ups doesn’t know the proper estimated runtime or charge level of lifepo4 batteries. This is a relatively minor issue compared to above. Technically, a 48v lifepo4 pack that fits most UPS battery compartments could be built to handle several of the issues above. As an experiment, I fully charged up 4 of these individually outside a UPS, then installed them in the ups. Verified the output of the pack was approx 55.8v. The charge/discharge circuit ”popped” with the telltale electronics burning smell, with smoke, when a 200w load AC power fail test was triggered. These batteries may be ok for some cases, like the single battery backup common to home alarm system panels.

I bought these for my Cyberpower UPS. They don't fit with the plate that goes between the batteries. I used wooden blocks to make the space between the cells to fit my UPS, but these Nermak batteries are a couple of mm taller than the SLA batteries that they are replacing. This was enough that I had to remove the plate in my unit. The USP is operating normally and isn't getter hotter than before. I'm confident that these cells will last much longer than the 3 years that I got from the last cells that I had in there. Also, the cells were within a few hundredths voltage from each other when they arrived, so I didn't have to balance them before installation. I may inspect them in a few months to verify that all continues to be well.

3 of the 4 batteries I received still work and charge. One battery seems to have died and will not take a charge. Apparently the return window is up and I can't get support. Would not recommend simply because one of the batteries have already died. I purchased in February 2026. Nermak reached out and refunded me the amount for the battery. Customer service team stepped up where the battery failed and made things right. This shows they stand behind their products and understand sometimes things happen. I appreciate the assistance and have adjusted my review rating due to exceptional communication and customer service.

They have been working so far.