PowerDeWise Dual Lavalier Microphone Set for iPhone, Android & Camera – Professional Clip-On Lapel Microphones for Interviews, Podcasting, YouTube, Video Recording, Vlogging & Online Teaching

I evaluated four different lavalier mics for use in creating software tutorial videos. This is my favorite one overall. Sound quality is very good, with good low-frequency performance that flatters the male voice. I used it with a traditional USB computer sound device having an XLR connector with 48 Volt phantom power and a low-noise microphone preamp. Be aware that if you use the mic in this application, you'll need an XLR-to-TRS adapter for 3.5 mm connectors. You can't just use any adapter though, but must use one that takes the 48 Volt phantom power from the sound device's XLR connector and steps it down to the much lower voltage of 4 Volts for the mic. Otherwise, you'll destroy the mic with 48 Volts. One such adapter is the Rode VXLR Pro. That device also contains a transformer to convert the balanced XLR signal to unbalanced, while eliminating ground loops. Additionally, to use this adapter, you must use the adapter cable that comes with the PowerDewise mic. This adapter cable converts the mic connector, which has a tip, 2 rings and a sleeve (TRRS) to a standard TRS connector with tip and sleeve, but only one ring, exactly as headphones have. I'll call this the "TRRS-to-TRS adapter cable" below.In this application, the PowerDewise mic had lower noise than all the lavalier mics I tried, except for the expensive Rode Lavalier II, which is only slightly less noisy. Sound quality of the PowerDewise was as good as the Rode Lavalier II. This makes it an exceptional value.There is one caveat though. A YouTube user reported failures of more than one of the included TRRS-to-TRS adapter cables I described above. Because of this possibility, I recommend using an adapter plug that Amazon sells instead. The plug is not susceptible to the failure mode apparently caused by flexing or pulling of the adapter cable. This adapter plug is sold as "3.5mm TRS Male (for Camera/Camcorders) to 3.5mm Female TRRS Microphone Adapter". This adapter also had a beneficial side effect in my setup. Using the included adapter cable, the residual noise of the mic, while not having any hum or buzz, did not sound like pure hiss either, but had a sort of "gritty" characteristic to it. With the aftermarket adapter plug, the grittines went away and the noise level dropped, sounding like pure hiss afterward. Apparently the included TRRS-to-TRS adapter cable is not adequately shielded. In my setup, it was positioned right on top of my computer, so it was probably picking up digital noise. The mic output is in the microvolts at this point, so it's going to be sensitive to noise pickup there.An added bonus of this mic is that the included lapel clips are adjustable - a very nice touch. They also sell replacement clips, so I got a couple of spares. The length of the cord was more than adequate at about 6 feet, unlike the expensive Rode Lavalier II. Appearance is fine, although if you want to totally conceal it, a more specialized (and expensive) mic like the Rode is a better choice.All in all, a great purchase.

I purchased the the PowerDeWise Professional Grade 2 Lavalier Clip-On Microphones Set for Dual Interview, and I must say, I am impressed with its performance. This microphone set proved to be a valuable tool for my ZOOM calls as they give me freedom of movement. .One of the standout features of these lavalier microphones is their excellent fidelity. The sound quality captured by the dual lav lapel setup is clear, crisp, and highly professional. Whether I was using them with my iPhone or a camera, the audio captured was of impressive quality, enhancing the overall production value of my videos.However, I must note that after a limited period of use, the lapel mic holder broke. While this was disappointing, I reached out to the company, and they swiftly addressed the issue. The customer service team promptly replaced the clips free of charge, which speaks volumes about their commitment to customer satisfaction.To avoid such an issue, I recommend potential buyers to ensure they get a kit that includes the fix for the lapel mic holder. This will save you from any potential inconvenience and ensure that you can fully enjoy the benefits of this microphone set without any hiccups.Apart from this minor setback, the PowerDeWise Professional Grade 2 Lavalier Clip-On Microphones Set has proven to be a reliable and versatile choice for dual interviews. The noise-canceling feature worked impressively well, minimizing background noise and capturing clean audio, even in challenging environments.Additionally, the 3.5mm connection is compatible with a wide range of devices, making it convenient to use with smartphones, cameras, and other recording equipment. The long cable length provides flexibility during interviews, allowing freedom of movement without compromising audio quality.the PowerDeWise Professional Grade 2 Lavalier Clip-On Microphones Set is a valuable tool for content creators, interviewers, and vloggers. The fidelity of the audio is exceptional, and the noise-canceling capabilities greatly enhance the overall recording experience. While there was an issue with the lapel mic holder, the company's swift response and replacement of the clips without any additional charges demonstrate their commitment to customer satisfaction. I recommend this microphone set, but do make sure to get a kit that includes the fix for the lapel mic holder to ensure a hassle-free experience.

I bought this dual lav mic kit for two reasons:1. I want to create YouTube videos, but the mic on my DSLR just doesn't live up to how I think my audio should sound.2. This kit is one of the most affordable lav microphone options, it gets good reviews--and as a bonus, it has 2 lav mics!This is the first set of lav mics I've ever owned. I've had my kit for 2 months (as of this writing), and so far I'm pretty happy.As for pros and cons, there's only one--and to me, it's pretty significant:For whatever reason, these mics pick up gobs of 'interference noise' which results in a horrible "hum" in my audio recordings. My DSLR has a headphone jack, so I can monitor audio during recording. The hum comes through very clearly--so I did some experimenting... I discovered that when the microphone cables are near computer monitors, computers, lights, other wires--basically anything electric on my desk, they pick up very loud interference. I don't know if all wired lav mics do this or not--but it does happen with my PowerDeWise kit. As a result, I tried recording in a location with no electric stuff anywhere near my camera or microphone cables--and the hum vanished.Now for the good stuff--These mics sound great. The audio quality I get with these mics in my DSLR video recordings is MUCH better than the on-camera mics. I'm not an audio expert, so I'm not sure how to describe the sound, but these PowerDeWise mics have a decent sound range, that results in a pleasant, slightly muted sound, with good low tones. There's not a lot of "S" hissy sounds. If I remove the foam windscreen, I pick up more "S" hiss sounds in my voice, but it's minimal. Overall, I love how these mics sound.The alligator clips on the mics are a good solid plastic, and they have a nice solid "bite" to hang on to clothes. The clips don't have a "broadcast loop" clip--so if you need to set these up with that loop, you gotta loop the wire through the alligator clip the old fashioned way.The kit itself is also great. It comes with everything shown--2 mics with decently long cables, 2 extension cables, one Y-splitter (so I can record interview style videos with two people on one camera), and one small adapter cable so I can connect the mics to my camera. Each cable comes with little hook-n-latch straps, so I can coil up the wires, and secure things neatly. The kit also comes with a nice little zipper bag to store everything in, a microfiber cloth, and a couple of extra foam windscreens.PowerDeWise customer service really impressed me. Right after I received my kit, I had questions, so I emailed PowerDeWise. They replied promptly, and were very courteous and professional. They not only answered my questions, but they took extra steps to ensure my needs were met. I haven't seen that level of customer service in a long time.If you can work around the 'interference noise' these mics sometimes pick up, you'll love this kit.The price is right, the kit has everything you need to get started, and the sound quality is so much better than any on-camera mic I've ever used.

I'm in my last semester of college and I'm doing a bunch of cinema production courses. Since classes are all remote this semester, I've had to procure my own equipment, and lavalier mics were first on my list to buy for our documentary unit. I've been using these mics with a Zoom H4N and it works beautifully (just turn on the plug-in function and use the 4 to 3 pin adapter). The sound quality is wonderful, the set is well organized, and it comes with everything you need. I especially love that it comes with a little carrying pouch that fits everything in it, a splitter, cable extenders, and the prong adapter!! It's very easy to use and sounds great.If you are looking for professional-sounding audio (and easier file management), I recommend plugging these into an external audio recorder where you can monitor the sound and recording levels. That's why I'm so happy this came with the prong adapter! Very versatile.Overall I really recommend this kit. I'm very excited to use them for projects.

Microphones are not headsets! And your stash of old audio output cables are not going to work. It is important to use the included cables, Y connector, and the 4 pin to 3 pin adapter when connecting to a PC, digital recorder or camera audio input.The 3.5mm plugs from the mics are a 4 contact TRRS type. The signal from the mic is presented on the S (shield) pin, and ground is on R2 (the ring closest to the shield). R1 (ring closest to tip) and T (the tip) are not used.Inputs to consumer devices are often 3 pin TRS (Left channel on the tip, Right channel on the ring, and ground on the shield. When it comes to 4 pin TRRS inputs, well it depends. Apple devices seem to be T=Left, R1=Right, R2=Ground, S=Mic. Non-Apple seems to be T=Left, R1=Right, R2=Mic and S=Ground. Those of us familiar using the shield as ground for audio out, might think that Apple is nuts BUT the Apple input scheme is closer to the typical microphone/instrument configuration. This flip of the mic/ground connections might not matter, but if you find yourself troubleshooting the source of hum/noise etc. keep this in mind.What all of this means is that you need to keep your box of old audio cables tucked neatly away, far from these excellent mics, and use the cables provided. This includes third party TRRS to TRS conversion cables/plugs. They will not work!Lastly, my learning from making a lot of mistakes, revealed the obvious. These mics have one signal therefore are mono; both of them! The signals presented on the 3 pin TRS that you plug into your recorder are also mono. I am not sure if this results in a balanced input (read up on balanced / unbalanced inputs if you need a cure for insomnia), but if you are thinking you will get a left track from one mic and a right track from the other, sorry!I had a problem with my Tascam DR-05 (old version) with the cables, Y connectors, and TRRS/TRS provided with these mics. The DR-05 Left track was being recorded at a higher level than the Right. Maybe that had something to do with the phantom power from the DR-05 (which must be turned on). Selecting Mono or Stereo on the DR-05 didn't matter. So I contacted the manufacturer for support. Their support was excellent and prompt by the way. Within a few days, I received a new Y cable. Beats me what the difference is, but the replacement Y cable solved my problem. Now both the L and R tracks recorded on the DR-05 are the same level.Overall, I am thrilled with the mics and the support from the manufacturer. I hope my fumbling through all of this, and this rambling review might be helpful to some others.

Useful. Good sound quality.

I ordered these in order to have podcast interviews. The idea is brilliant, but the sound quality is not. The sound quality is just not impressive at all! It sounded kind of hollow and there was an odd base mixed in. When I used both mics through the splitter, I found that the sound level was so low that once I boosted it high enough to be heard there was to much background noise and hiss. I removed the background noise quite successfully but then it sounded like you were talking on the phone or something.Another concern, that could have solved the previous one, is that their adapter intended to make the mikes work with traditional AV Equipment instead of just phones didn't work right. I managed to get it to work (kind of) with my Sabrent USB Audio Stereo Sound Adapter (See photo). But when I put it into a 1/4 in adapter to plug into my podcast mixer, it simply wouldn't work at all. At first I thought the adapter was faulty and PowerDeWise sent a replacement out right away, but the new adapter didn't solve the problem.Pros:Great concept!Low priceCompactIt will work on your phone as is its main function (albeit with poor audio quality)The company was easy to work with.Replacement part sent right away.Cons:Poor Audio QualityAdapter didn't work correctly (it will not work with at traditional 1/4 in audio set-up, even with the adapter they provide)Basically there are a lot more pros than cons, but for me the con of poor audio quality trumps all the pros.Unfortunately I took to long to satisfy myself that my problems were not on my end so now I cannot return them.

I purchased these to use with my DJI Mic 2 system because the other lavalier (clip) mics I had generated a harsh hum with the DJI system. I'm mostly retired but do occasional videos for non-profit organizations and, though I operate on a tight budget, I like to provide top quality. Multiple reviews and comparison videos led me to this purchase and I'm not disappointed. To my ears, the sound quality is very good, the same as the DJI mics without a lavalier plugged in, and generates no discernible hum or distortion. I did have one small problem, one of the broken magnetic clips became loose and broke when I tried to squeeze it tighter (see photo). The company promptly replaced the clip at no charge by sending me an additional complete mic set. The mic comes with a long cord AND extension. The mic cord is a bit too long for my uses but it's easily coiled up with the included Velcro keeper. The mics are nicely packaged in a cloth case with extension cords and adapters.