Ductless HVAC Mini Split Mounting Bracket - AC Wall Bracket (9K-36K BTU)

This product is very reasonable on the pocket and easy and stable after assembley for use. It also had a very good fit on our wall we didn't know if it was gonna and it did and ia very very compatible for our living situation

Awesome mount! worked perfect for the Pioneer Mini split install.

Instructions say the top horizontal arm holds no weight and weight must be placed on the fasteners of the 2 vertical arms. So Its nice to hit 2 studs. Unfortunately I did not, and hit 1 stud..Then Drilled a 1/2 inch hole into the stud. Trying to install a toggle bolt...Luckily, after careful deliberation I filled the 1/2 inch hole with exterior wood glue and a piece of half inch dowel, and was able to capture, at least, 1 vertical arm with the included lag bolt fasteners on a stud. The other arm got the toggle bolts. Unfortunately I could not locate a stud for 1 vertical arm. After doing some heavy engineering maths on 3 or 4 different types of fasteners I used, I came up with the number of how much weight this could hold, based on the fasteners, and it was well over 4x the 60 lbs. I weighed my condenser at. Using the engineering maths weights I felt comfortable doing a few dips off of the mounting bracket to check my work. I do believe the top horizontal arm does add some structural support and the manual is saying dont depend on it, just forget the top arm exists when making your engineering weight calculations with fasteners and what youre mounting into. Now that the mount is mounted with fasteners. The quality of the mount is there. Its fully capable of securing the 55 lbs of load. The rubber feet dampeners do help with noise reduction and I consider what is included robust for the quality of the dampener. Most importantly is the arms length. Its a little longer and gets my unit farther away from a flush mount with the wall. This is important to increase the efficiency of the unit as it tries to draw in air from behind it. You want these long arms to give more room behind the unit.

Worked great for the heat pump I bought. Very strong and very easy to install.

This is a great bracket to use for a mini split unit. However, we only got half the hardware and didnt realize it until we were installing, so had to run to harware store for more. Easy to put together and install. Works great.

Great quality easy to install and came with all the hardware needed

Wonderful and easy to install! Comes with all hardware and even some super nice easy to install rubber feet. Don’t look anywhere else, this is the best!

This wall mount is great,I bought a 2nd one I was so impressed with the first. What I believe sets this apart from the majority of the other mounts, is the bracket that you mount to slide both of the legs into allows you to easily line up and adjust the width of the compressor mounts vs. the other mounts which require you to be pretty much dead on when you mount them width wise. The same is for the depth of the mounting feet which give you plenty of adjustment for pretty much any mini split mounting footprint. The mount is well built and solid and I don't foresee any issues with it. I used them both, one for an 18k compressor and also a 12k compressor. There was still plenty of adjustments for the mounting pads that I'm sure would accommodate up to the largest mini split compressors. The anti-vibration pads work great and were easy to install and line up. I would highly recommend this mount as I don't think it can be beat both for the price and quality and ease of mounting. 7 stars

Most the stuff dose not fit well together , expensive for no point,be aware

parfait

Great!

Bon produit solide Très robuste aucune inquiétude

Good unit although the lag bolts seem a bit large for the plastic anchors which are themselves rather large.