CB Antenna 28 inch 27 Mhz CB Radio Antenna Full Kit with Heavy Duty Magnet Mount Mobile/Car Radio Antenna Compatible with President Midland Cobra Uniden Anytone by LUITON

ATTACHED IT TO PRORTABLE CB RADIO, AND PICKS UP NICELY LONG TRANSMISSIONS. ATTACHES BY MAGNET

The antenna worked as it should but the magnet is not strong enough for highway speeds on top of a vehicle. That is unless it is blocked by something to reduce wind on it. Great entry antenna and awesome customer service from this company. Unfortunately I put the antenna on the roof of my vehicle and it didn’t last long at 70+mph speeds. The company made it right and I definitely will be buying from them again

Worked perfectly the antenna wire is a great length plenty to work with. good size went together very easy the magnet is pretty strong.looks good.it mite feel kind of flimsy at first but once secured its not bad.overall good product.

The produt is a cb antena.. for some it may serve their purpose. For myself it did not. I ended up having to purchase a different one due to the vehicle more than the antena. It would dismount at 65mph the magnet would not hold it to my pickup. THIS IS NOT THE FAULT OF THE ANTENA MAKER. It turns out the new vehicles lack the amount of steel it takes for a 45lb magnet. I bought a different antenna same result. I ended up purchasing a 95lb magnet and fabricating the antenna in order to get it to mount to the new magnet. Then mounted it to the truck. Now it stays put. The antenna itself works as a cb antenna. It was the magnet and my vehicle that were the problem.

Got this antenna for my old school c.b. radio! Received signals perfectly! Great value!

1. The magnetic base isn't strong enough, it blew off after the first trip. I affixed it to my roof with silicon which proved to be a huge mistake. 2. The whip is thin, non-spring steel. It is very easily bent and it stays bent. 3. There is no "forgiveness" in the tuning. If you trim the antenna too short, there is no backing out. I never got better than 3.0 SWR. If I'm generous, I'll chalk this up to user error. 4. I removed the antenna after only a few weeks and there was already a substantial amount of rust leaching from the magnetic base out onto my roof. 5. The screw in mount is not the typical 3/8 inch bolt and the coax is permanently connected. This means that if you need to replace the whip then the base and all of the wire also has to be removed.

Works as advertised. I had a 1.7 SWR so didn't trim the antenna. You can coil and uncoil the cable to tweak it a little. Magnet holds well and road speed..

Got this as a next-day delivery, since I was headed out of town and wanted to be on sideband while I drove. My old mag mount cable got pinched and shorted out. This was not much better.... the whip is very flimsy, the magnet does stick but needs a bigger footprint. The package came with no instructions, so I tried the lock washer on the bottom and the mid-mount point. No difference, but where the bottom post meets the spring, that transition (chrome to brass) was not soldered , just pinched. That came loose, and even when trying to tune the whip (SWR never got below 2.0), it always measured too short for CB Frequencies. As I was removing it the final time, the center load cover seemed like it was loosening. From now on for my radio stuff I'm buying recognizable brand names.