Universal High Tension Ring (Medium, 2 Pack)

I purchased the MEDIUM because it was noted in the listing that most men would need MEDIUM Standard tension ring. Since I have considerable issues maintaining usable firmness, I opted for the medium HIGH tension ring. I don't have a loader (yet) and the outside diameter of my current cylinder is too large to load the ring anyway, so I tried to stretch this ring and install it to see how much affect I could receive. I managed to barely get it on while flaccid but the more concerning issue was that it was NEAR IMPOSSIBLE to remove without pulling the head off my penis, even using the tabs on the sides. I may end up needing the LARGE even though I don't consider my girth to be that great. I may even need a standard tension just for ease of removal, if the high tension rings are that hard to remove. I may investigate the Erecaid EZ rings instead, if I can find a suitably sized cylinder without resorting to purchasing the genuine Erecaid pump. My next step besides purchasing a smaller diameter cylinder is to buy an Osbon Erecaid loader system which I found online for a reasonable amount (too bad Amazon doesn't currently sell it).

This high tension ring is equivalent in strength to the standard tension of the OEM. As for the standard tension ring, it's virtually useless. Way too soft.

Did not work every one I purchase were not good broke every time they were used products are no good

Not enough tension.